Blog Archives

If I had the time, I’d build every project with hand-cut mortise and tenon or dovetail joinery. But that’s not a very realistic goal, nor is it necessary. There are plenty of joinery methods out there that can be made both quickly and easily. During the seminar podcast, I’ll talk about three of my favorite “quick and easy” joinery methods.

One of the most “traditional” methods is the lap joint. It’s easy to cut with just one setup on the table saw. And it provides plenty of face grain gluing surface as well as a good amount of mechanical strength.

For a couple of “modern” joinery techniques that are especially quick and easy, you’ll have to purchase specialized machinery to produce them. I’m talking about biscuit joints and pocket hole joinery. Both of these methods get their mechanical strength from distinctive fastener’s — biscuits or pocket screws. But the best part is that each can be setup and cut in seconds.

Be sure to check out the Woodsmith Podcast Store for links to a few products that I used during this seminar.

You can sharpen your woodworking skills with helpful tips and techniques from the editors of Woodsmith and ShopNotes magazines. Get a FREE tip sent to your email address each week! Go to WoodworkingTips.com and sign up today.

Here’s last week’s tip from ShopNotes online editor Phil Huber:

I wanted to add an auxiliary table and fence to my drill press. But I didn’t want to spend a lot of money. So I built the simple drill press table and fence with a replaceable insert you see in the photo above. The fence is adjustable and has a sliding stop.

Table

The table is two layers of ¾″ plywood that are glued together. A dado on the top side at each end holds T-tracks for attaching the fence. Two bottom-mounted T-tracks attach the table to the drill press, as you can see in detail ‘b’ and the photo at right.

Fence

The fence is nothing more than a length of aluminum angle. A slotted hole at each end accepts a flange bolt from the table so you can quickly mount and adjust the fence to meet almost any drilling challenge.

Stop Block

To help position and hold the workpiece, I added a stop block to the fence. It’s simply a block of wood attached to an aluminum bracket. A knob and T-nut, are used for adjusting the block and securing it in position on the fence (detail ‘a’).

You can find even more ways to upgrade your power tools, just go to: plansnow.com/toolstandplans.html.

Good Woodworking,

Phil Huber
Online Editor, ShopNotes

Send for a preview issue of ShopNotes magazine

You can sharpen your woodworking skills with helpful tips and techniques from the editors of Woodsmith and ShopNotes magazines. Get a FREE tips sent to your email address each week! Got to Woodworking Tips.com and sign up today.

Here’s last week’s tip from Woodsmith online editor Ted Raife:

The easiest way to make a lidded box is to build the box and lid as one piece and then cut them apart on the table saw. This guarantees that the lid will be a perfect fit to the box. With a little modification, this same technique can be used to make a box and lid that mate with interlocking lips, as shown in the photo at right.

This technique for making a box lid is a little different in that you do part of the job before the box is assembled. A look at the two drawings will explain. To create the lip, you’ll need to cut halfway through the sides from both the inside and the outside. As shown in Figure 1, the inside cuts are made while the box is still in pieces. Remember that this first cut will form the “high” side of the lip.

Once the box is assembled, you complete the job with a second series “halfway” cuts that are offset a blade’s width (¹/₈″) from the first (Figure 2). These cuts are positioned below the first cuts. If you hit it right, the lid will separate cleanly and after a little sanding, you’ll have a snug-fitting, lipped lid.

For more helpful table saw tips and techniques, visit Plansnow.com.

Good Woodworking,

Ted Raife
Online Editor, Woodsmith

Send for a preview issue of Woodsmith magazine